Elite IPK Document Revision 1
Programming Manual 2 - 51
___________________________________________________________________________________
___________________________________________________________________________________
1-1-47 Access Code (2-Digit) Assignment
General Description
Use this Memory Block to assign a 2-digit number as an Access Code.
Display
Notes
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
DG
to access the Memory Block.
3 Enter the options using the dial pad.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
4 Enter the Function Number for the Dial Number. Refer to the table in Memory Block 1-1-46 [Access Code (1-Digit) Assignment].
5 Press
G
to display next dial number in succession.
6 After programming last Dial No., press
G
to display the next Memory Block.
7 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-48
Access Code (3-Digit) Assignment
1. Select options from the list of function numbers in Memory Block 1-1-46 [Access Code (1-Digit) Assignment], and
assign a number (from 00~99),
,
, or
#
to each selected function.
H
When a function is assigned a 1-digit Access Code, 2-digit Access Codes with the same first digit become
invalid (i.e., if a function is assigned to Access Code 5, Access Codes 50~59, 5
,
, and 5
#
cannot be used).
2. To enter
#
or
,
as part of an Access Code, press
B
then
L
or
J
.
3. Use this Memory Block when a 4-Digit Station Numbering Plan is programmed.
System Mode
1
Submode
1
Data No.
47
PC Programming
¦
+BA
4 7 : 2 D G ( 0 0 ) = 0 0 0
T I M E D I S P L A Y
Function
No.
Data
No.
Dial
No.
0~9
*#
Title
To Next Page
Loading...
