NEC Electra Elite IPK - Private Line Assignment

2 - 36 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-1-29 Private Line Assignment
General Description
Use this Memory Block to assign an outside line as a private line. The private line
cannot be seized by any other telephone, and an LED indication is not provided to
other terminals.
Display

Notes

Programming Procedures
1 Go off-line.
2
Press LK1 +
LK1 +
BI
to access the Memory Block.
3 Enter the data using the dial pad.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K ~ I
to enter numeric data
H
to clear all data when cursor is at CO No. or Tel. Port No.
Default Values
Not Specified
4
Press
G
to write the data. Data for the second line is displayed. Move the cursor to change the data.
5 Press
G
to write the data and display the next Memory Block.
6 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
2-06
Line Key Selection for Tenant Mode
4-12
Line Key Selection for Telephone Mode
1. Two private lines can be assigned to one station or one private line can be assigned to two stations.
2. A Single Line Telephone (SLT) user cannot dial the Trunk Group Access Code to access a private line. The
Single Line Telephone user can dial the specified Line Seizure Access Code assigned in Memory Blocks 1-1-46/
1-1-47 [Access Code (1-digit/2-digit) Assignment], Function 063 or 064 to access the line.
3. When a station is allowed Barge-In originate, and a second station is allowed Barge-In receive, Barge-In is not
allowed on a private line unless both stations share the private line.
System Mode
1
Submode
1
Data No.
29
PC Programming
¦ +BCS
2 9 : P 1 C = T =
T I M E D I S P L A Y
CO No.
(01~64)
Data
No.
Combination
No.
(1/2)
Title
Tel. Port No.
(01~CO)