NEC Electra Elite IPK - System Data List

1 - 12 Multiline Terminal Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
SECTION 3 SYSTEM DATA LIST
The System Data List is a complete list of Memory Blocks that are available in the
Elite IPK system. The information is organized by mode, submode, and then
numerically by Memory Block number. The Memory Block number and name, the
default values, and programming values are provided for each Memory Block.
LK 1 System Mode
LK 1 CO Line
Data
No.
Memory Block Name Default Value Programming Values
00 Pause Time Selection 3.0s
1.0s, 3.0s
01 DP Interdigit Time Selection B
Pattern A or B
02 Hookflash Time Selection 600ms
20ms, 40ms, 60ms, 80ms, 100ms, 140ms,
160ms, 200ms, 400ms, 600ms, 800ms,
1.0s, 1.5s, 2.0s, 3.0s, 5.0s
03 Hold Recall Time Selection
(Non-Exclusive Hold)
25s
25s, 45s, 60s, 90s, 120s, 180s, 240s,
∞
(No Limit)
04 Automatic Redial Time Selection Table 1: 030
Table 2: 060
Table 3: 002
Table 1: 001 ~ 050 sec.
Table 2: 001 ~ 100 sec.
Table 3: 001 ~ 015 times
05 Start Time Selection 10s
2s, 10s, 20s, 30s, 40s, 50s, 60s, 70s
06 CO/PBX Incoming Ringing Alarm
Time Selection
∞ (No Limit)
10s, 20s, 30s,
∞
07 Tie Line Delay Ringing Time
Selection
∞ (No Limit)
10s, 20s, 30s,
∞
09 Manual Pause Selection NO
NO, YS
11 System Transfer/Camp-On
Selection
YS
NO, YS
12 Station Transfer/Camp-On Recall
Time Selection
45s
25s, 45s, 60s, 90s, 120s, 180s, 240s,
∞
(No Limit)
13 CO Transfer Ring Pattern Selection C
OFF, ON, A ~ H
14 CO Transfer Ring Tone Selection A
A ~ H
18 System Speed Dial Restriction by
Tenant
CO/PBX Line LED
On
LED On: Not Restricted
LED Off: Restricted
20 DID Digit Length Selection 3
2, 3, or 4