NEC Electra Elite IPK Programing Manual

2 - 4 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-1-02 Hookflash Time Selection
General Description
Use this Memory Block to specify the loop open time for a hookflash signal sent to the
CO or PBX when the Recall key on a Multiline Terminal is pressed. A Single Line
Telephone (SLT) generates a hookflash to the CO or PBX line when a Single Line
Telephone hookflash is assigned.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
20ms 40ms 60ms 80ms 100ms 140ms 160ms 200ms
Page 2
LK 1
LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
400ms
600ms 800ms 1.0s 1.5s 2.0s 3.0s 5.0s
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1
+
KB
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.

Use the following to enter data:
C
to go to the next page
A
to go to the previous page
4
Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
1
Data No.
02
PC Programming
¦ +BCM
0 2 : F L S H 6 0 0 m s | 2
T I M E D I S P L A Y
Data
Setting
Title
Data
No.
Page
No.

NEC Electra Elite IPK Specifications

General

Brand	NEC
Model	Electra Elite IPK
Category	Telephone
Language	English