NEC Electra Elite IPK - ACD;UCD Group Pilot Number Assignment

Elite IPK Document Revision 1
Programming Manual 2 - 269
___________________________________________________________________________________
___________________________________________________________________________________
1-12-00 ACD/UCD Group Pilot Number
Assignment
General Description
Use this Memory Block to specify the Pilot Number of an Automatic Call Distribution/
Uniform Call Distribution (ACD/UCD) Group where incoming calls are terminated.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK12 to access the Memory Block.
3 Enter data using the dial pad.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data

Setting Data:
Pilot No.
2-digit (00~99)
3-digit (000~999)
4-digit (0000~9999)
Default Values
Not Specified
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program Memory Block 1-12-01 and 1-12-02. The next Group No. is displayed.
6 Repeat Steps 3, 4, and 5 for each Group No. After Group 4 is programmed, Group 1 for Memory Block 1-12-00 is displayed.
7 Press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-47
Access Code (2-Digit) Assignment
1-1-48
Access Code (3-Digit) Assignment
1-2-03
2-, 3-, 4-Digit Station Number Selection
System Mode
1
Submode
12
Data No.
00
PC Programming
¦ +AA
0 1 / 0 0 : P I L O T =
T I M E D I S P L A Y
Data
No.
Setting Data
(Pilot No.
max. 4 Digits)
Group No.
(1~4)
Title