Programming Manual A - 1
___________________________________________________________________________________
___________________________________________________________________________________
Function Time Chart
Appendix A
SECTION 1 TIME CHART
The chart on the following pages provides a list of times that can be programmed in
the system. The information is listed numerically by Memory Block number. A brief
definition and Minimum, Default, and Maximum values are given for each time.
Table A-1 Function Time Chart
Time
Memory
Block
Definition
Value
Minimum Default Maximum
Pause Time
Selection
1-1-00 Time when no signal is being
sent to a CO/PBX line.
1.0s 3.0s 3.0s
DP Interdigit Time
Selection
1-1-01 Minimum time between dialing
signals in Dial Pulse dialing.
ABB
Hookflash Time
Selection
1-1-02 Timing of a CO/PBX hookflash
from the Recall key of a
Multiline Terminal or a Single
Line Telephone to the CO/PBX
line.
20ms 600ms 5.0s
Hold Recall Time
Selection
(Non-Exclusive
Hold)
1-1-03 The time before a held CO/PBX
line recalls the station that put
that line on hold.
25s 25s
∞
Automatic Redial
Time Selection
1-1-04 Defines the redial timing
parameters when automatic
redial is set to a busy CO/PBX
number.
Table 1 001
Table 2 001
Table 3 001
030
060
002
050 sec.
100 sec.
015
Attempts
Start Time Selection 1-1-05 The time after dialing before
the system starts the elapsed
Call Time.
2s 10s 70s
To Next Page
Loading...
