2 - 288 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-14-02 ARS Dial Allow/Deny Selection
General Description
Use this Memory Block to specify whether or not to Allow digits that are entered in the
ARS dialing assignment to be routed using the ARS feature.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
YES NO
Programming Procedures
1 Go off-line.
2 Press LK1 + LK14 +
KB
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
Use the following to enter data:
K
~
I
to select data
J
to move cursor left
L
to move cursor right
4 Press
G
to write the data. The next Dial No. is displayed.
5 Repeat Steps 3 and 4 for each Dial No. (01~C8) for Table 1. After Dial No. C8 is programmed, the next Table No. is displayed.
6 Repeat Programming cycle for each Dial No.(01~C8) for Tables 2~4. The next Memory Block is displayed.
7
Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03
Trunk-to-Trunk Group Assignment
4-40
LCR Class Selection
1-1-30
Route Advance Block Assignment
1-8-08
Class of Service (Station) Feature Selection 2
1-14-00
ARS Allow/Deny Selection
1-14-01
ARS Dial Allow/Deny Selection
System Mode
1
Submode
14
Data No.
02
PC Programming
¦
+AB
0 2 : 1 / 0 1 A / D Y E S
T I M E D I S P L A Y
Table
No.
1~4
Setting
Data
Data
No.
Dial
No.
Title
To Next Page
Loading...
