Elite IPK Document Revision 1
Programming Manual 2 - 93
___________________________________________________________________________________
___________________________________________________________________________________
1-1-82 CO Feature Code Service for Code
Restriction
General Description
Use this Memory Block to define a code to send to the CO in front of the dialed
number to allow completion of a CO call made to a Code restricted number set to
allow.
Notes
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
HB
to access the Memory Block.
3 Use the dial pad to enter the Feature Code for Restriction to Code Table 01.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
Default Values
Not specified
4 Press
G
to write the data.
5 Repeat Steps 3 and 4 for all code Tables. The next Memory Block is displayed.
6 Program the next Memory Block or press
E
to go back on-line.
Example: Set Code Table 01 to
,
67
When Tel 100 user dials Access Code 9, Feature Code
,
67 Telephone Number 12147517000 to access a line
that is code restricted, the code restriction starts at 12147517000. When code restriction is set to allow, the 1214
matches and the call goes through. When Code restriction is deny, the 1214 matches and user receives a reorder
tone and ERROR is displayed on telephones that have a display.
System Mode
1
Submode
1
Data No.
82
PC Programming
¦
+AC
8 2 : 0 1 =
T I M E D I S P L A Y
Data
No.
Code
Table
01~10
Setting
Data
To Next Page
Loading...
