NEC Electra Elite IPK - DID Limit to Tenant Assignment

2 - 378 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
2-09 DID Limit to Tenant Assignment
General Description
Use this Memory Block to assign the number of DID calls allowed to ring at a specified
tenant.
Display

Notes

Programming Procedures
1 Go off-line.
2 Press LK2 +
KI
to access the Memory Block.
3 Enter Setting Data using the dial pad.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
Default Values
00 (No Limit)
01~64 Incoming Calls
4 Press
G
to write the data. The next Tenant No. for Memory Block 2-01 is displayed.
5 Program all Tenants. After Tenant 47 is programmed, the display cycles back to Tenant 01 of Memory Block 2-01.
6 Press
E
to go back on-line.
Only DID incoming calls are limited. Outgoing calls, Internal (ICM) calls, and normal incoming calls are not
limited.
System Mode
2
Submode
—
Data No.
09
PC Programming
¦ + BN
0 0 : 0 9 : L I M I T 0 0
T I M E D I S P L A Y
Setting
Data 00~64
Data
No. Title
Tenant
No.