Elite IPK Document Revision 1
Programming Manual 2 - 19
___________________________________________________________________________________
___________________________________________________________________________________
1-1-14 CO Transfer Ring Tone Selection
General Description
Use this Memory Block to select a ring tone for CO transfers.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
A B C D E F G H
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 +
AD
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
The available tones are:
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-11
System Transfer/Camp-On Selection
1-1-13
CO Transfer Ring Pattern Selection
System Mode
1
Submode
1
Data No.
14
PC Programming
¦
+BCS
1 4 : C O T R F T O N E A
T I M E D I S P L A Y
Title
Data
No.
Setting
Data
Tone Frequency
Tone A 480/600 (Modulation - 16 Hz)
Tone B 480/606 (Modulation - 8 Hz)
Tone C 1024/1285
Tone D 1024
Tone E 500
Tone F 1024/1285 (Modulation - 16 Hz)
Tone G 600/700 (Modulation - 16 Hz)
Tone H 1024 (Envelope - 2 sec.)
To Next Page
Loading...
