NEC Electra Elite IPK - Trunk Status Selection

2 - 380 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
3-02 Trunk Status Selection
Use this Memory Block to specify whether a CO/PBX line is used for call origination
and termination or termination only.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK8 The shaded
selection is the
default.
OUT&IN IN
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
to access the Memory Block.
3 Press the corresponding CO/PBX Line Key to change the option.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
02
PC Programming
¦ +
BCT
0 1 / 0 2 : O U T & I N
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Setting Data
Data
No.