NEC Electra Elite IPK - Intercom Feature Access Code Assignment

Electra Elite IPK Document Revision 1
Programming Manual 2 - 111
___________________________________________________________________________________
___________________________________________________________________________________
1-2-24 Intercom Feature Access Code
Assignment
General Description
Use this Memory Block to assign the Access Code for Voice/Tone change or Step
Call.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BD
to access the Memory Block.
3
Use the dial pad to enter the Setting Data.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
B
+
,
or # to enter
,
or #
4 Press
G
to write the data and advance to the next Dial No.
5
Repeat Steps 3 and 4 for each Dial No. The next Memory Block is displayed.
6
Program the next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
2
Data No.
24
PC Programming
¦ +BA
2 4 : F E A A C ( 0 ) = 0 0 4
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
Dial
No.
Setting Data
Setting Code Feature
000 Not Used
001 Voice/Tone Switching
002 Step Call
003 Tone Override
004 Automatic Callback
005 Callback Request
006 Voice Over Originate
007 Quick Transfer to Voice Mail
Default Values
Dial Numbers
0 = 004
1 = 001
2 = 002
3~5 = 000
6 = 006
7 = 007
8, 9 = 000
,
= 003
# = 005