NEC Electra Elite IPK - 1-16-08 High Priority TX Tag Assignment

Elite IPK Document Revision 1
Programming Manual 3 - 349
___________________________________________________________________________________
___________________________________________________________________________________
1-16-08 High Priority TX Tag Assignment
General Description
When a packet is received without a Tag, this Memory Block can add a High Priority
Packet Tag for each port of the HUB(8)-U( ) ETU.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
KH
to access the Memory Block.
3 Use dial pad keys to enter Setting data.

Use the following to enter data:
Use
J
to move cursor left
Use
L
to move cursor right
Use
K
~
I
to enter numeric data

Priority range is lowest 0~7 highest.
Default Values
:
All ports = 7
4 Press
G
to write the data.
5 Repeat steps 3 and 4 for each port.
6
Press
E
to go back on-line.
System Mode
1
Submode
16
Data No.
08
PC Programming
¦ +AB
0 8 : 1 - 1 H I G H T X = 7
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3