NEC Electra Elite IPK - Slt Data Line Security Assignment

2 - 536 Memory Blocks
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
4-90 SLT Data Line Security Assignment
General Description
Use this Memory Block to specify NORMAL or DATA position for a Single Line
Telephone (SLT).
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NORMAL DATA
Programming Procedures
1 Go off-line.
2 Press LK4 +
IK
to access the Memory Block.
3
Press LK2 to select DATA for single Line telephones for Tel Port No.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D
to go to next assigned Tel Port No.
B
+
A
to enter A for Port Numbers 100~109
B
+
B
to enter B for Port Numbers 110~119
B
+
C
to enter C for Port Number 120
Default Values
Ports 01~CO = NO
4 Press
G
to write the data and display the next Memory Block.
5
Program Memory Blocks 4-91~4-95. The next Tel Port No. is displayed.
6
Repeat Steps 3, 4, and 5, for all Tel Port Nos. Tel Port No. 01 is displayed again for Memory Block 4-90.
7 Press
E
to go back on-line.
Telephone Mode
4
Submode
—
Data No.
90
PC Programming
¦ +BTT
Data
No.
0 1 / 9 0 : S L T N O R M A L
T I M E D I S P L A Y
Title
Tel
Port
No.
(01
~
C0)
Setting
Data