NEC Electra Elite IPK - Table 1-2 Multiline Terminal Keys Used for Programming

Elite IPK Document Revision 1
Programming Manual 1 - 7
___________________________________________________________________________________
___________________________________________________________________________________
Table 1-2 Multiline Terminal Keys Used for Programming provides a
list and description of the keys used during Multiline Terminal
Programming.
Table 1-2 Multiline Terminal Keys Used for Programming
Key
Description
K
~
I
Used to enter data from the dial pad or to specify a Memory Block
location.
J
Used to move the cursor to the left. The cursor moves one character
space to the left each time
J
is pressed.
L
Used to move the cursor to the right. The cursor moves one character
space to the right each time
L
is pressed.
F
Used to select another mode. Press
F
to switch modes as follows:

Mode or submode selection: Returns to Program Mode.

Data No. Mode: Return to a mode or submode selection, or
Program Mode (if no submode exists).
D
Each time the conference key is pressed, Memory Block item changes
are as follows:

Tenant Mode: The tenant number increments by one.

CO/PBX Line Mode: The CO/PBX line number increments by one.

Telephone Mode: The telephone port number increments by one.

Trunk Group Mode: The Trunk group number increments by one.
Y
Future use.
A
Used to return to the previous page in system programming.
X
Future use.
H
Used to enter a pause in speed dial programming mode or to clear data
in system programming mode.
W
Flexible Line keys are used to specify a mode or submode when
selecting a Memory Block or to select programming data for input.
C
Used to proceed to the next page in system programming.