NEC Electra Elite IPK - Tandem Transfer Automatic Disconnect Time Selection

Elite IPK Document Revision 1
Programming Manual 2 - 129
___________________________________________________________________________________
___________________________________________________________________________________
1-4-00 Tandem Transfer Automatic
Disconnect Time Selection
General Description
Use this Memory Block to specify maximum time, in minutes, before the system
automatically disconnects a Trunk-to-Trunk connection.
Display
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.

Notes

Programming Procedures
1 Go off-line.
2 Press LK1 + LK4
to access the Memory Block.
3 Use the dial pad to enter data.

Use the following to enter data:
K
~
I
to enter numeric data
J
to move cursor left
L
to move the cursor right
Setting Data: 001~999 Minutes
000 No Limit
H
:
Data Clear
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
This block is used for Direct Inward System Access (DISA), Trunk-to-Trunk Transfer, Call Forward – Off-Premise,
and Tie line tandem features.
System Mode
1
Submode
4
Data No.
00
PC Programming
¦ +AT
0 0 : A U T O D I S 0 6 0
T I M E D I S P L A Y
Setting
Data
Data
No.
Title