Elite IPK Document Revison 1
Programming Manual 2 - 425
___________________________________________________________________________________
___________________________________________________________________________________
3-42 DIT Assignment
General Description
Use this Memory Block to assign a Day Mode direct trunk termination to an
independent station.
Display
Notes
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
DB
to access the Memory Block.
3 Enter data for CO/PBX No. using the dial pad to assign DIT to a station.
Use the following to enter data:
J
to moves the cursor left
L
to moves the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX Line No.
Enter the following:
Station No. (2-, 3-, or 4-digits 00~9999)
CO Port No. (01~64)
Default Values
No Assignment
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-43
ANA Assignment
A trunk can terminate at only one station, but any number of trunks can terminate at the same station.
CO/PBX Line Mod
To Next Page
Loading...
