2 - 292 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-14-04 ARS Trunk Group to Route Number
Assignment
General Description
Use this Memory Block to specify whether a Trunk Group, Route Advance Block, or
ICM is used for each Route assignment.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
NORMAL
(Originate)
TKGP
(01~32)
RAB
(01~32)
ICM
Programming Procedures
1
Go off-line.
2 Press LK1 + LK14 +
KD
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the Setting Data 1 option.
Use the following to enter data:
K
~
I
to select Data Setting Data 2 Trunk Group Number (01~32) or Setting Data 2 RAB (01~32).
J
to move cursor left
L
to move cursor right
4 Press
G
to write the data. The next Route No. is displayed.
5 Repeat steps 3 and 4 for each Route No. The next Memory Block is displayed.
6 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03
Trunk-to-Trunk Group Assignment
4-40
LCR Class Selection
1-1-30
Route Advance Block Assignment
1-8-08
Class of Service (Station) Feature Selection 2
1-14-00
ARS Allow/Deny Selection
System Mode
1
Submode
14
Data No.
04
PC Programming
¦
+AB
0 4 / 0 1 = N O R M A L
T I M E D I S P L A Y
Route
No.
Setting
Data 2
Data
No.
Setting
Data 1
To Next Page
Loading...
