NEC Electra Elite IPK - Tone Assignment

2 - 200 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Electra Elite IPK
1-8-15 Tone Assignment
General Description
Use this Memory Block to assign each system tone to the flexible tables.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
A B C DE FG H
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
I J K L M
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
AE
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.

Use the following to enter data:
K ~ I
to enter Table No.
C
to alternate between pages
4 Press
G
to write the data and advance to the next table.
5 Repeat Steps 3 and 4 for each remaining table. The next Memory Block is displayed.
6 Program the next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
8
Data No.
15
PC Programming
¦ +BI
Data
No.
1 5 : ( 0 0 ) D T = A | 1
T I M E D I S P L A Y
Tone
Setting
Data
Page
No.
Table
No.
(00 ~12)