NEC Electra Elite IPK - DP Interdigit Time Selection

Elite IPK Document Revision 1
Programming Manual 2 - 3
___________________________________________________________________________________
___________________________________________________________________________________
1-1-01 DP Interdigit Time Selection
General Description
The DP Interdigit Time is the minimum pause time between Dial Pulses. Use this
Memory Block to Select either Pattern A or Pattern B.
Display
Settings

Notes

LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK7 LK8 The shaded
selection is the
default.
A
B
Programming Procedures
1 Go off-line.
2
Press LK1 + LK1
+
KA
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4 Press
G
to write the data and display the next Memory Block.
5
Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-92
Trunk (Installed, DP/DTMF) Selection
Use this Memory Block when DP Tie lines or DID are assigned in Memory Block 3-92 [Trunk (Installed, DP/
DTMF) Selection] to send Dial Pulse signaling.
System Mode
1
Submode
1
Data No.
01
PC Programming
¦ +BCM
0 1 : D P I N T E R B
T I M E D I S P L A Y
Data
No.
Title
Data
Setting
DP Dial
Data
10 pps 20 pps
Pattern A 650 ms. 500 ms.
Pattern B 800 ms. 800 ms.
Dial
Minimum
Pause
Time
Signal
Dial
Signal