NEC Electra Elite IPK - 1-11-02 Line Length Selection

Elite IPK Document Revision 1
Programming Manual 2 - 261
___________________________________________________________________________________
___________________________________________________________________________________
1-11-02 Line Length Selection
General Description
Use this Memory Block to specify the distance, in feet, between the channel service
unit/demarcation (CSU/D mark) and the DTI-U( ) ETU. This specifies the equalization
values of the detect signal in the DTI-U( ) ETU.
Display
Settings

Notes

LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
1
(0 - 131)
2
(132 - 262)
3
(263 - 393)
4
(394 - 524
5
(525 - 655)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK11 +
KB
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
System Mode
1
Submode
11
Data No.
02
PC Programming
¦ +AD
0 1 / 0 2 : L I N E = 1
T I M E D I S P L A Y
Data
No.
Setting
Data
DTI No.
(01~08)
Title
Line Key
LCD
Indication
Description
LK 1 1 0~131 feet
LK 2 2 132~262 feet
LK 3 3 263~393 feet
LK 4 4 394~524 feet
LK 5 5 525~655 feet