Elite IPK Document Revision 1
Programming Manual 3 - 353
___________________________________________________________________________________
___________________________________________________________________________________
1-16-10 Port Mirroring Selection
General Description
Use this Memory Block to specify whether or not Port Mirroring is enabled for each
HUB(8)-U( ) ETU.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
NO
(Normal)
YS
(Mirror)
Programming Procedures
1
Go off-line.
2 Press LK1 + LK16 +
AK
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the option.
4
Press
G
to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.
6
Press
E
to go back on-line.
System Mode
1
Submode
16
Data No.
10
PC Programming
¦
+AB
1 0 : 1 M I R R O R N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
HUB
1~3
To Next Page
Loading...
