2 - 8 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-1-05 Start Time Selection
General Description
Use this Memory Block to specify the time after dialing before the system starts the
Elapsed Call Time.
Display
Settings
Notes
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
10s 20s 30s 40s 50s 60s 70s 2s
Programming Procedures
1
Go off-line.
2 Press LK1 +
LK1 +
KE
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-5-25
SMDR Valid Call Time Assignment
This time is used for the features with functions described below:
Elapsed Call Time: The time after dialing before the Elapsed Call Time is started and displayed on a Multiline
Terminal.
SMDR Start Time: The time needed after dialing before the SMDR Valid Call Time is started. Refer to Memory
Block 1-5-25 (SMDR Valid Call Time Assignment). For outgoing calls, both Elapsed Call Time and SMDR Valid
Call Time must elapse before a call record is generated.
System Mode
1
Submode
1
Data No.
05
PC Programming
¦
+BM
0 5 : C A L L S T A R T 1 0 s
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
To Next Page
Loading...
