Elite IPK Document Revision 1
Programming Manual 3 - 345
___________________________________________________________________________________
___________________________________________________________________________________
1-16-06 Port Based Priority Selection
General Description
Use this Memory Block to specify the Quality of Service (QoS) mode for each port of
each HUB(8)-U( ) ETU.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
NO
(Not
Assigned)
LO
Low
HI
High
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
KF
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G
to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.
6
Press
E
to go back on-line.
System Mode
1
Submode
16
Data No.
06
PC Programming
¦
+AB
0 6 : 1 - 1 Q o S N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3
To Next Page
Loading...
