2 - 370 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
Notes
Programming Procedures
1 Go off-line.
2 Press LK2 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
D
to go to the next assigned Tenant No.
C
to go to the next page.
A
to go to the previous page
Data Options:
Default Values
Tenant 00 = All trunks are assigned
Tenant 01~47 = Not assigned
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program Memory Blocks 2-05~2-09. The next Tenant No. is displayed.
6 Repeat steps 3, 4, and 5 for each Tenant No. Memory Block 2-01 Tenant 00 is displayed.
7 Press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
2-05
Line Key Selection
4-09
Telephone to Tenant Assignment
When data is changed while the system is busy, DATA ENTRY is displayed at the programming station until the
system becomes idle.
\
CO/PBX
Line LED
Off
On
Data
No
(Not Assigned)
Yes
(Assigned)
To Next Page
Loading...
