NEC Electra Elite IPK - Automated Attendant Direct Extension Ring Assignment

Elite IPK Document Revision 1
Programming Manual 2 - 151
___________________________________________________________________________________
___________________________________________________________________________________
1-4-22 Automated Attendant Direct
Extension Ring Assignment
General Description
Use this Memory Block to specify the Automated Attendant message to be played for
direct transfer to the extension number.
Display

Notes

Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
JJBB
to access the Memory Block.
3 Use the Dial pad to enter Station Number for AA MSG 1.

Use the following:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
2-Digit Station Number: 10~99
3-Digit Station Number: 100~999
4-Digit Station Number: 1000~9999
H
to clear all data when cursor is at setting position
Default Values
No Message Specified
4 Press
G
to write the data and display the next AA MSG.
5 Repeat Steps 3 and 4 for each AA MSG. The next Memory Block is displayed.
6 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46,47
Access Code (1-Digit, 2-Digit) Assignment
1-2-03
2-, 3-, or 4-Digit Station Number Selection
The CAR Number and AA number can also be assigned as Extension Number. When Extension Number is not
assigned, the Memory Block 1-4-08 time is followed.
System Mode
1
Submode
4
Data No.
22
PC Programming
¦ + AU
2 2 : A A T R F 1 =
T I M E D I S P L A Y
AA MSG
1~8
Setting
Data
Data
No.
Title