NEC Electra Elite IPK - Tie Line Wink;Delay Signal Detect Timeout Selection

2 - 408 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
3-25 Tie Line Wink/Delay Signal Detect
Timeout Selection
General Description
Use this Memory Block to specify a maximum time, in seconds, for receiving an
acknowledgment signal from a distant system before sending a busy tone.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7
LK 8
The shaded
selection is the
default.
•
(No Limit
1s 2s 3s 4s 5s 6s
7s
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
8s 9s 10s 11s 12s 13s 14s 15s
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
BE
to access the Memory Block.
CO/PBX Line Mod
e
3
Submode
—
Data No.
25
PC Programming
¦ +ALM
0 1 / 2 5 : D T E C T 7 s | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Page
No.
Setting
Data