NEC Electra Elite IPK - Automated Attendant Message Day;Night Mode Selection

2 - 138 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-4-11 Automated Attendant Message Day/
Night Mode Selection
General Description
Use this Memory Block to specify whether or not Automated Attendant messages can
be used in a Day/Night Mode setting.
Display
Settings
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
YS
NO
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
JJAA
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option for AA MSG1 in DY (Day) Mode.

Use the following to enter data:
A
~
H
to enter numerical data
B
to toggle between Day Mode and Night Mode
4 Press
G
to write the data, and display the next message.
5 Repeat steps 3 and 4 for all eight messages. The next Memory Block is displayed.
6 Return to this Memory Block, toggle
B
to select NT (Night) and repeat Steps 3, 4, and 5 for all messages for night Mode.
The next Memory Block is displayed.
7 Program the next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
4
Data No.
11
PC Programming
¦ +AU
1 1 : A A M S G 1 ( D Y ) = N O
T I M E D I S P L A Y
Title
Data
No.
A.A.
Msg.
NO.
1~8
Day/
Night
Mode
Setting
Data