3 - 34 Advanced Applications
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
3.3.14 Line Key Selection for Tenant Mode (Memory Block 2-06)
Use this Memory Block to assign functions to each telephone line
key for Tenant Mode.
Default: Tenant 00, Line keys 01~08 are assigned to CO/PBX.
Tenants 01~47 are unassigned)
3.3.15 Trunk-to-Trunk Group Assignment (Memory Block 3-03)
Use this Memory Block to assign a Trunk Group number to each CO/
PBX line.
Default:Lines 01~08 assigned to Trunk Group 01
Lines 09~64 assigned to Trunk Group 00
All Tie Lines assigned to Trunk Group 02
All DID lines assigned to Trunk Group 00
3.3.16 Trunk Incoming Answer Mode Selection (Memory Block 3-05)
Use this Memory Block to specify the incoming answer mode per
outside line as NO ASSIGN (Normal), TANDM TRF (automatic trunk-
to-trunk transfer), or AA (Automated Attendant/DISA).
Default: NO ASSIGN
3.3.17 Automatic Release Signal Detection Selection (Memory Block 3-40)
Use this Memory Block to specify signal detection time for release of
a CO/PBX line after a disconnect signal is received from the Central
Office or PBX.
Default: 350 (milliseconds)
3.3.18 DIT Assignment (Memory Block 3-42)
Use this Memory Block to assign a Day Mode direct-trunk
termination to an independent station.
Default: Blank (No Assignment)
3.3.19 ANA Assignment (Memory Block 3-43)
Use this Memory Block to assign a Night Mode direct-trunk
termination to an independent station.
Default: Blank (No Assignment)
3.3.20 ISDN Trunk Directory Number Assignment (Memory Block 3-52)
Use this Memory Block to assign ISDN Directory Number.
Default: Blank (Not Specified)
To Next Page
Loading...
