NEC Electra Elite IPK - Automated Attendant Transfer Ring Pattern

Elite IPK Document Revision 1
Programming Manual 2 - 63
___________________________________________________________________________________
___________________________________________________________________________________
1-1-54 Automated Attendant Transfer Ring
Pattern
General Description
Use this Memory Block to specify the ringing pattern or no ring sent to the Multiline
Terminal when an incoming call is received at the Automated Attendant and
transferred.
Display
Settings
Page 1
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
A B
C D E F G H
Page 2
LK 9 LK 10 LK 11 LK 12 LK 13 LK 14 LK 15 LK 16
NO
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
ED
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.

Use the following to enter data:
C
to access the next page
A
to access the previous page
4
Press
G
to write the data and display the next Memory Block.
5
Program the next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
1
Data No.
54
PC Programming
¦ +AU
5 4 : A A P T N C | 1
T I M E D I S P L A Y
Data
No.
Title
Page
No.
Setting
Data