Elite IPK Document Revision 1
Programming Manual 1 - 9
___________________________________________________________________________________
___________________________________________________________________________________
3. Dial
L
,
K
, and
J
in sequence. The Multiline Terminal LCD
indicates program mode is now active.
While off-line, the programming terminal cannot be signaled by
any system station. Off-line mode does not timeout.
2.5.4 Page Switching
In Memory Block 1-1-18 (System Speed Dial Restriction by Tenant)
tenant numbers 00~07 are assigned to Flexible Line keys on the first
page. Tenant number 08~15 are assigned to the Flexible Line keys
on the second page. The tenant number corresponding to Flexible
Line key 1 of the current page is displayed on the right side of the
display.
During system programming, a value (data) is assigned to each
Flexible Line key. When the number of values exceeds the number
of Flexible Line keys, value assignments are displayed on additional
pages. The associated data can be entered on that page. The page
number is displayed on the right side of the LCD.
Figure 1-3 Page Display for 8-Key, 16-Key and 24-Key Multiline
Terminals shows an example of CO/PBX line keys on each page and
their corresponding tenant numbers. In all cases, each page is
represented by eight line keys.
To navigate between pages, press
C
to access the next page, or
press
A
to return to the previous page.
P R O G R A M M O D E
T I M E D I S P L A Y
To Next Page
Loading...
