NEC Electra Elite IPK - 1-16-11 Mirroring Source Port Assignment

Elite IPK Document Revision 1
Programming Manual 3 - 355
___________________________________________________________________________________
___________________________________________________________________________________
1-16-11 Mirroring Source Port Assignment
General Description
Use this Memory Block to specify an output port for each HUB(8) -U( ) ETU when Port
Mirroring is enabled.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
AA
to access the Memory Block.
3 Use dial pad keys to enter Setting Data.

Use the following to enter data:
Use
J
to move cursor left
Use
L
to move cursor right
Use
K
~
I
to enter numeric data

Port range is 1~8.
Default Values
:
Port 1
4 Press
G
to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.
6 Press
E
to go back on-line.
System Mode
1
Submode
16
Data No.
11
PC Programming
¦ +AB
1 1 : 1 S O U R C E = 1
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
HUB
1~3