2 - 534 Memory Blocks
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
4-68 LCD Line Key – Name Assignment
General Description
Use this Memory Block to assign a name to each LCD Line Key of the DTH/
DTR-16LD-1 Telephone. Up to eight characters can be assigned.
Display
Programming Procedures
1 Go off-line.
2
Press LK4 +
FH
to access the Memory Block.
3 Use the dial pad to change Line key number or name.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
t
o enter Name, Line key number or Tel Port No.
– OR –
D
to go to next assigned Tel Port No.
B
+
A
to enter A for Port Numbers 100~109.
B
+
B
to enter B for Port Numbers 110~119.
B
+
C
to enter C for Port Number 120.
Default Value
LK01~08: C0 01~08
4
Press
G
to write the data and display the next Line key and name.
5 Repeat Steps 3 and 4 for each Line key assignment. After Line key 16 is
programmed, the next Tel Port No. is displayed. When you want to program less
than 16 keys, after the last Line key to program, press
D
to go to next
assigned Tel Port No. After all Tel Ports are assigned, the next Memory Block is
displayed.
6 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-2
Telephone Type Assignment
4-12
Line Key Selection for Telephone Mode
CO/PBX Line Mod
To Next Page
Loading...
