Elite IPK Document Revision 1
Programming Manual 2 - 23
___________________________________________________________________________________
___________________________________________________________________________________
1-1-20 DID Digit Length Selection
General Description
Use this Memory Block to define the number of Direct Inward Dialing (DID) digits in
Memory Block 1-1-22 (DID Digit Conversion Table).
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 +
BK
to access the Memory Block.
3 Enter the data using the dial pad.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
H
to clear all data
Default Values
3 (Setting Data 2, 3, or 4)
4
Press
G
to write the data and display the next Memory Block.
5
Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-21
DID Digit Conversion Assignment
1-1-22
DID Digit Conversion Table
1-1-23
DID Forward Station Number for Busy Station or Undefined Digit
5-00
Digit Add/Del For Tie Line Networking Assignment
System Mode
1
Submode
1
Data No.
20
PC Programming
¦
+ALN
2 0 : D I D D G T 3
T I M E D I S P L A Y
Setting
DataTitle
Data
No.
Title
To Next Page
Loading...
