NEC Electra Elite IPK - DID Forward Station Number for Busy Station or Undefined Digit

Elite IPK Document Revision 1
Programming Manual 2 - 27
___________________________________________________________________________________
___________________________________________________________________________________
1-1-23 DID Forward Station Number for
Busy Station or Undefined Digit
General Description
Use this Memory Block when Memory Block 1-1-22 (DID Digit Conversion Table) is
enabled to define where digits are routed when undefined or the station is busy.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
NON
T
(TEL)
TN
(Tenant)
Programming Procedures
1 Go off-line.
2
Press LK1 +
LK1 +
BC
to access the Memory Block.
3 Enter Setting Data 1 using the Line key.
Enter Setting Data 2 using the dial pad.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data

TEL is 2-, 3-, or 4-digit number (10~99, 100~999, or 1000~9999)

Tenant number can be 00~47
Default Values
NON
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-22
DID Digit Conversion Table
System Mode
1
Submode
1
Data No.
23
PC Programming
¦ +ALN
2 3 : T R F E X = N O N
T I M E D I S P L A Y
Setting
Data 1
Title
Data
No.
Setting
Data 2
Setting
Data 2