NEC Electra Elite IPK - Automated Attendant PBR Start Time Selection

Elite IPK Document Revision 1
Programming Manual 2 - 137
___________________________________________________________________________________
___________________________________________________________________________________
1-4-09 Automated Attendant PBR Start Time
Selection
General Description
Use this Memory Block to specify whether the Push Button Receiver (PBR) can
receive dual-tone multifrequency (DTMF) signaling while the Automated Attendant is
sending the message or after the message is complete.
Display
Settings
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.

Notes

LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
FR AF
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK4 +
JI
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Setting Data:
FR: While the Automated Attendant sends the message.
AF: After the Automated Attendant sends the message.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
When FR is assigned, the Automated Attendant message send start time and the PBR connected to Automated
Attendant trunk start time are the same.
System Mode
1
Submode
4
Data No.
09
PC Programming
¦ +AU
0 9 : P B R S T R T F R
T I M E D I S P L A Y
Setting
Data
Title
Data
No.