NEC Electra Elite IPK - 1-16-00 Auto Negotiation Yes;No Selection

Elite IPK Document Revision 1
Programming Manual 3 - 333
___________________________________________________________________________________
___________________________________________________________________________________
1-16-00 Auto Negotiation Yes/No Selection
General Description
Use this Memory Block to specify whether or not Auto Negotiation is enabled for each
port of the HUB(8)-U( ) ETU. When No is selected, Memory Block 1-16-01 (Port
Speed Selection 10/100 Base -T) and Memory Block 1-16-02 (Port Duplex Mode
Selection) are used.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
YS NO
Programming Procedures
1 Go off-line.
2
Press LK1 + LK16 +
KK
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G
to write the data.
5 Repeat steps 3 and 4 for each Port.
6 Press
E
to go back on-line.
System Mode
1
Submode
16
Data No.
00
PC Programming
¦ +AB
0 0 : 1 - 1 A U T O Y S
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3