NEC Electra Elite IPK - Hookflash Start Time Selection

Elite IPK Document Revision 1
Programming Manual 2 - 123
___________________________________________________________________________________
___________________________________________________________________________________
1-3-05 Hookflash Start Time Selection
General Description
Use this Memory Block to specify the minimum hookflash time from a Single Line
Telephone or analog Voice Mail system before it is detected as the beginning of a valid
hookflash.
Display
Settings
Page 1

Notes

LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default. The
times are in
milliseconds.
40 90 140 190 240
290 340 390
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
440 490 540 590 640 690 740 790
Programming Procedures
1 Go off-line.
2 Press LK1 + LK3 +
KE
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.

Press
C
to cycle between pages.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-3-01
Bounce Protect Time Selection
1-3-06
Hookflash End Time Selection
Press hookswitch during CO/PBX call to place the line on hold or send hookflash to CO/PBX.
System Mode
1
Submode
3
Data No.
05
PC Programming
¦ +BTI
0 5 : F L S H S T 2 9 0 | 1
T I M E D I S P L A Y
Data
No.
Title
Page
No.
Setting
Data