Elite IPK Document Revison 1
Programming Manual 2 - 387
___________________________________________________________________________________
___________________________________________________________________________________
3-07 CO/PBX Ringing Variation Selection
General Description
Use this Memory Block to specify a ringing tone for each CO/PBX line.
Display
Settings
Notes
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
M
(Medium)
L
(Low)
H
(High)
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
KG
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the ringing tone for CO/PBX.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-28
Distinctive Ringing by Telephone or CO Selection
1. This Memory Block is not applicable when Telephone is selected in Memory Block 1-1-28 (Distinctive Ringing by
Telephone or CO Selection).
2. High, medium, or low ringing tone applies to incoming outside line calls only.
CO/PBX Line Mod
To Next Page
Loading...
