NEC Electra Elite IPK - Hold Tone Source Assignment

Electra Elite IPK Document Revision 1
Programming Manual 2 - 213
___________________________________________________________________________________
___________________________________________________________________________________
1-8-31 Hold Tone Source Assignment
General Description
Use this Memory Block to assign an internal or external Music on Hold source.
Display
Settings
LK 1 LK 2 LK 3 LK 4 The shaded
selection is the
default.
INT EXT
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
CA
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the MOH source.
Default Values
INT
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-09
Music On Hold Pattern Selection
1-8-32
Hold Internal Tone Volume Selection
System Mode
1
Submode
8
Data No.
31
PC Programming
¦ +BCS
3 1 : H L D T S R C I N T
T I M E D I S P L A Y
Data
No.
Setting
DataTitle