NEC Electra Elite IPK - Trunk External Receive Pad Selection

Elite IPK Document Revison 1
Programming Manual 2 - 419
___________________________________________________________________________________
___________________________________________________________________________________
3-32 Trunk External Receive Pad Selection
General Description
Use this Memory Block to specify receive dB volume level for tandem calls between a
local system and two distant systems.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default. Settings
are in dB.
246812163-3
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
0
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
CB
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change eternal receive pad for CO/PBX No.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
C
to go to the next page.
A
to go to the previous page.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
32
PC Programming
¦ +BCT
0 1 / 3 2 : P A D E R 0 | 2
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data Page