NEC Electra Elite IPK Programing Manual

2 - 406 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
3-24 Tie Line Incoming Interdigit Timeout
Selection
General Description
Use this Memory Block to specify the time, in seconds, that an address signal is
missing during the incoming call detection process before an error tone is returned to
the other system.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6
LK 7 LK 8
The shaded
selection is the
default.
∞
(No Limit)
1s 2s 3s 4s 5s
6s 7s
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
8s 9s 10s 11s 12s 13s 14s 15s
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
BD
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change incoming interdigit timeout for CO/PBX No.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
C
to go to the next page.
A
to go to the previous page.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
24
PC Programming
¦ +ALM
0 1 / 2 4 : I N C O M 6 s | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64
Data
No.
Title
Page
Setting
Data

NEC Electra Elite IPK Specifications

General

Brand	NEC
Model	Electra Elite IPK
Category	Telephone
Language	English