NEC Electra Elite IPK - Automatic Tandem Trunk by Night Mode Selection

Elite IPK Document Revision 1
Programming Manual 2 - 135
___________________________________________________________________________________
___________________________________________________________________________________
1-4-05 Automatic Tandem Trunk by Night
Mode Selection
General Description
Use this Memory Block to specify whether or not the Automatic Trunk-to-Trunk
Transfer feature follows the Night Mode assignment.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
JE
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-27
Automatic Day/Night Mode Switching Time Assignment
1-1-33
Speed Dial Number/Name Display Selection
3-05
Trunk Incoming Answer Mode Selection
3-06
Automatic Tandem Trunk Assignment
System Mode
1
Submode
4
Data No.
05
PC Programming
¦ +AT
0 5 : T A N D B Y N T N O
T I M E D I S P L A Y
Setting
Data
Title
Data
No.