NEC Electra Elite IPK - COM Port Parity;Stop Bit Setting Assignment

2 - 218 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Electra Elite IPK
1-8-36 COM Port Parity/Stop Bit Setting
Assignment
General Description
Use this Memory Block to specify the Parity and Stop bit for the individual COM ports.
Display
Settings

Notes

LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NON/1 NON/2 EVEN/1 ODD/1
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
CF
to access the Memory Block.
3
Press the corresponding CO/PBX line key to select the parity and stop bit setting
.
Default Values
COM 1 = Non/1
COM 2 = Non/1
COM 3 = Non/1
4 Press
G
to write the data, and advance to the next COM port.
5 Repeat steps 3 and 4 for each remaining COM port. The next Memory Block is displayed.
6 Program next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-5-13
Printer Connected Selection
COM 1 = PC Programming
COM 1 = LCR
COM 2 = Station Message Detail Recording (SMDR)
COM 3 = Automatic Call Distribution [Not used by Electra Elite IPK Basic Port Package (48).]
System Mode
1
Submode
8
Data No.
36
PC Programming
¦ +CSS
3 6 : P / S 1 = N O N / 1
T I M E D I S P L A Y
Title
Data
No.
Setting
Data