NEC Electra Elite IPK - Enhanced 911 Trunk Assignment

2 - 222 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Electra Elite IPK
1-8-43 Enhanced 911 Trunk Assignment
General Description
Use this feature to define an available loop-start trunk as a CAMA or an ISDN PRI
trunk. When a user dials 911, the system seizes the E911 trunk and sends additional
digits (CESID) to enable the PSAP center to recognize the callback telephone number.
The E911 trunk must be connected to a COI(4)/(8)-U( ), COID(4)/(8)-U( ), COIB(4)-U(
), or COIB(8)-U( ) Loop Start port and assigned to the system.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
DC
to access the Memory Block.
3 Use the dial pad to specify CO/PBX number to assign the CAMA trunk.

Use the following to enter data:
K
~
I
to enter numeric data
J
to move cursor left
L
to move the cursor right

Setting Data: CO/PBX 01~64 (Default not specified)
H
:
Data Clear
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number
Memory Block Name
1-8-44
Enhanced 911 Alternate Route Assignment
1-8-45
Enhanced 911 Alternate Route Assignment (Maintenance Busy)
1-8-46
Enhanced 911 Dialing Digit Assignment
4-54
Enhanced 911 CESID to Station Table
System Mode
1
Submode
8
Data No.
43
PC Programming
¦ +AE
Data
No.
4 3 : 9 1 1 T R U N K
T I M E D I S P L A Y
Setting
Data
Title