NEC Electra Elite IPK - Tie Line Prepause Time Selection

2 - 394 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
3-16 Tie Line Prepause Time Selection
General Description
Use this Memory Block to specify the time (prepause) before the originating side can
send dial pulse or dual-tone multifrequency (DTMF) to the distant system.
Display
Settings
Page 1

Notes

LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default. Times
are in seconds.
0 0.5 1.0 1.5 2.0 3.0 4.0 5.0
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
6.0 7.0 8.0 9.0 10.0 11.0 12.0 13.0
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
AF
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change prepause time for CO/PBX No.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
C
to go to the next page
A
to go to the previous page
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
1. Prepause time differs according to the acknowledgment signaling method.
2. This Memory Block affects T1 channels assigned as Tie/DID lines.
CO/PBX Line Mod
e
3
Submode
—
Data No.
16
PC Programming
¦ +ALM
0 1 / 1 6 : P R E 0 | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data
Page
No.