NEC Electra Elite IPK - Tie Line Dial Tone Selection

2 - 410 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
3-27 Tie Line Dial Tone Selection
General Description
Use this Memory Block to specify whether or not to send a dial tone to the distant
system.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO
YS
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
BG
to access the Memory Block.
3 Press Lk1 when you don’t want to send a dial tone to the distant system for CO/PBX No.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-14
Tie Line Type Assignment
CO/PBX Line Mod
e
3
Submode
—
Data No.
27
PC Programming
¦ +ALT
0 1 / 2 7 : S D T Y S
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data