2 - 260 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-11-01 Clear Channel Selection
General Description
Use this Memory Block to specify the clear channel selection. when the Zero Byte
Time channel is available, the CLKG-U( ) Unit cannot extract a clock signal from the
T1 trunk. The T1 trunk modifies the Zero Byte Time channel to extract a clock signal
for the CLKG-U( ) Unit.
Display
Settings
Notes
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
ZCS B8ZS
Programming Procedures
1 Go off-line.
2 Press LK1 + LK11 +
KA
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
System Mode
1
Submode
11
Data No.
01
PC Programming
¦
+AD
0 1 / 0 1 : O B Y T E = Z C S
T I M E D I S P L A Y
Data
No.
Setting
Data
DTI No.
(01~08)
Title
To Next Page
Loading...
