NEC Electra Elite IPK - 1-16-05 Default VLAN ID Assignment

Elite IPK Document Revision 1
Programming Manual 3 - 343
___________________________________________________________________________________
___________________________________________________________________________________
1-16-05 Default VLAN ID Assignment
General Description
Use this Memory Block to assign a default VLAN ID for an internal VLAN table for
each HUB(8)-U( ) ETU. When no Tag is received, the switching HUB can add a new
Tag and forward the packet to another port, and at that time, insert a VLAN ID that
corresponds to the received Media Access Control (MAC) address.
Display
Programming Procedures
1
Go off-line.
2 Press LK1 + LK16 +
KE
to access the Memory Block.
3
Use dial pad keys to enter Setting data.

Use the following to enter data:
Use
J
to move cursor left
Use
L
to move cursor right
Use
K
~
I
to enter numeric data

VLAN ID range is 0001~4095 (0x001~ 0xfff Hex).
Default Values
:
All ports = 0001
4
Press
G
to write the data.
5 Repeat steps 3 and 4 for each port.
6 Press
E
to go back on-line.
System Mode
1
Submode
16
Data No.
05
PC Programming
¦ +AB
0 5 : 1 - 1 I D = 0 0 0 1
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3