NEC Electra Elite IPK - Moh or Ring Back Tone Selection

Elite IPK Document Revison 1
Programming Manual 2 - 531
___________________________________________________________________________________
___________________________________________________________________________________
4-66 MOH or Ring Back Tone Selection
General Description
Use this Memory Block to assign MOH or Ring Back Tone for the outside party when a
trunk call is placed on hold by the Transfer key on a Multiline Terminal, hook flash from
a Single Line Telephone, or the Transfer or Hold key at a PSII station.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
MOH RBT
Programming Procedures
1 Go off-line.
2
Press LK4 +
FF
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the setting data option.

Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter Tel Port No.
– OR –
D
to go to next assigned Tel Port No.
B
+
A
to enter A for Port Numbers 100~109.
B
+
B
to enter B for Port Numbers 110~119.
B
+
C
to enter C for Port Number 120.
4 Press
G
to write the data and advance to the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
CO/PBX Line Mod
e
4
Submode
—
Data No.
66
PC Programming
¦ +BTT
0 1 / 6 6 : H O L D M O H
T I M E D I S P L A Y
Tel Port
No.
(01~CO)
Data
No.
Title
Setting
Data